數位天堂

小弟的一個Netgear R6300v1, 刷shibby的tomato (140 AIO版、138 AIO版), 十分不穩定。在TTL console看到的信息是會崩潰重啓。
本人刷機的過程：
1. 先按reset 15秒重啓，原廠固件內， 直接刷kongac的初始DD-wrt固件；
2. 進入DD-WRT後，按Reset 15秒重啓， 然後在DD-WRT 內刷Shibby的 140 AIO固件，等5-10分鐘。（期間在TTL console看到router 多次重啓）。
3. 能看到Tomato登入web後， 按reset 15秒重啓。 再次進入Tomato， 之後雙清。
4. 雙清期間兩次重啓後， 進入Tomato, reboot一次， 之後再次進入Tomato, 能看到5G WiFi。

但以上這樣操作後， Tomato 運行得十分不穏，經常重啓。我今晚可以post重啓的TTL 輸出。

請問壇內有朋友同樣使用Netgear R6300v1嗎？你們的使用情況如何？

謝謝！


以下是刷完shibby tomato固件後， ping 路由器的情況， 不是長期穩定的ping的時間（<1ms), 隔3-4個，會有一個很長的1xxxms的ping：
回覆自 192.168.1.1: 位元組=32 時間=730ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間=1301ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間=75ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間=730ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間=1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間=1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間=1332ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間=71ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
回覆自 192.168.1.1: 位元組=32 時間<1ms TTL=64
............


出現死機重啓時的TTL console信息如下：

..........
Call Trace:[<8018b808>][<80080008>][<80074164>][<80080cf8>][<8003dab0>][<8006d9dc>][<800726e0>][<80074b8c>][<80075294>][<800727e4>][<80073a34>][<80012464>][<80012464>]

Code: 7c420440  10400008  00000000 24420001  e0820018  10400e4f  00000000  03e00008
Fatal exception: panic in 5 seconds
Kernel panic - not syncing: Fatal exception
Rebooting in 3 seconds..Please stand by while rebooting the system...
Decompressing...done


CFE for R6300 version: v1.0.5
Build Date: Wed Nov 21 15:03:38 CST 2012
Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
Found a Samsung NAND flash with 2048B pages or 128KB blocks; total size 128MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138
CPU type 0x19749: 600MHz
Tot mem: 131072 KBytes

Device eth0:  hwaddr 20-E5-2A-01-BB-59, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Loader:raw Filesys:tftp Dev:eth0 File:192.168.1.2:vmlinuz Options:(null)
Loading: Failed.
Could not load 192.168.1.2:vmlinuz: Timeout occured
Checking crc...Loader:raw Filesys:raw Dev:nflash0.os File: Options:(null)
Loading: ...... 3191392 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
Linux version 2.6.22.19 (root@asus) (gcc version 4.2.4) #81 Wed Sep 3 01:10:55 CST 2014
CPU revision is: 00019749
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
Determined physical RAM map:
memory: 07fff000 @ 00000000 (usable)
Zone PFN ranges:
  Normal          0 ->    32767
  HighMem     32767 ->    32767
early_node_map[1] active PFN ranges
    0:        0 ->    32767
Built 1 zonelists.  Total pages: 32767
Kernel command line: root=/dev/mtdblock3 console=ttyS0,115200 init=/sbin/preinit
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM5300 rev 1 pkg 0 at 600 MHz
Using 300.000 MHz high precision timer.
console [ttyS0] enabled
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 126108k/131068k available (2518k kernel code, 4808k reserved, 397k data, 200k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI: Initializing host
PCI: Reset RC
PCI: Initializing host
PCI: Reset RC
PCI: Fixing up bus 0
PCI/PCIe coreunit 0 is set to bus 1.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:01:00.1 (0004 -> 0006)
PCI: Fixing up bus 1
PCI/PCIe coreunit 1 is set to bus 2.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:02:00.1 (0004 -> 0006)
PCI: Fixing up bus 2
NET: Registered protocol family 2
Time: MIPS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
io scheduler noop registered (default)
HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A
serial8250: ttyS1 at MMIO 0x0 (irq = 8) is a 16550A
PPP generic driver version 2.4.2
MPPE/MPPC encryption/compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V0.18.3
PPTP driver version 0.8.5
pflash: found no supported devices
Boot partition size = 262144(0x40000)
Creating 2 MTD partitions on "sflash":
0x00000000-0x00040000 : "pmon"
0x001f0000-0x00200000 : "nvram"
Found a Samsung NAND flash with 2048B pages or 128KB blocks; total size 128MB
lookup_nflash_rootfs_offset: offset = 0x0
nflash: squash filesystem with lzma found at block 8
Creating 2 MTD partitions on "nflash":
0x00000000-0x02000000 : "linux"
0x00118c44-0x02000000 : "rootfs"
NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit)
Creating 3 MTD partitions on "brcmnand":
0x00000000-0x02000000 : "trx"
0x02000000-0x04000000 : "jffs2"
0x04000000-0x07f00000 : "brcmnand"
dev_nvram_init: _nvram_init
_nvram_init: allocat size= 65536
usbcore: registered new interface driver hiddev
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
u32 classifier
    OLD policer on
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (1024 buckets, 8192 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
ipt_account 0.1.21 : Piotr Gasidlo , http://www.barbara.eu.org/~quaker/ipt_account/
net/ipv4/netfilter/tomato_ct.c [Sep  3 2014 01:10:54]
NET: Registered protocol family 1
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear
All bugs added by David S. Miller
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 200k freed
Warning: unable to open an initial console.
Failed to execute /sbin/preinit.  Attempting defaults...
emf: module license 'Proprietary' taints kernel.
et_module_init: passivemode set to 0x0
et_module_init: et_txq_thresh set to 0x0
bcm_robo_enable_switch: EEE is disabled
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.30.39.31 (r341183)
PCI: Enabling device 0000:01:01.0 (0000 -> 0002)
eth1: Broadcom BCM4331 802.11 Wireless Controller 6.30.102.9 (r366174)
PCI: Enabling device 0000:02:01.0 (0000 -> 0002)
eth2: Broadcom BCM4360 802.11 Wireless Controller 6.30.102.9 (r366174)
/ # lo: File exists

最後修改： fuyun (2017-08-03 23:28:11)