數位天堂

Xshell 4 (Build 0094)
Copyright (c) 2002-2011 NetSarang Computer, Inc. All rights reserved.

Type `help' to learn how to use Xshell prompt.
Xshell:\>

Connecting to COM3...
Connected.



U-Boot 1.1.4.2 (Jul 13 2010 - 20:06:30)

Board: Ubiquiti Networks XM board (rev 0.0 e0a5)
DRAM:  32 MB
Flash:  8 MB
Net:   eth0, eth1
Hit any key to stop autoboot:  0
## Booting image at 9f050000 ...
   Image Name:   MIPS OpenWrt Linux-2.6.32.10
   Created:      2011-09-24  16:54:53 UTC
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    854383 Bytes = 834.4 kB
   Load Address: 80060000
   Entry Point:  80060000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

Starting kernel ...

Linux version 2.6.32.10 (andy@andy-VirtualBox) (gcc version 4.3.3 (GCC) ) #2 Sun Sep 25 00:54:50 CST 2011
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR7240 rev 2, CPU:390.000 MHz, AHB:195.000 MHz, DDR:390.000 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 console=ttyS0,115200 root=31:03 rootfstype=squashfs board=DIR-600-A1 mtdparts=ar7240-nor0:256k(u-boot),64k(u-boot-env),1024k(kernel),6528k(rootfs),256k(cfg),64k(EEPROM)
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 29424k/32768k available (2022k kernel code, 3344k reserved, 385k data, 152k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:56
Calibrating delay loop... 259.68 BogoMIPS (lpj=1298432)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is D-Link DIR-600 rev. A1
registering PCI controller with io_map_base unset
bio: create slab at 0
PCI: fixup device 0000:00:00.0
pci 0000:00:00.0: PME# supported from D0 D1 D3hot
pci 0000:00:00.0: PME# disabled
PCI: mapping irq 48 to pin1@0000:00:00.0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY)  穢 2001-2006 Red Hat, Inc.
yaffs Sep 24 2011 22:19:27 Installing.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: mx25l6405d (8192 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x7e0000
Searching for RedBoot partition table in spi0.0 at offset 0x7f0000
No RedBoot partition table detected in spi0.0
spi0.0: no WRT160NL signature found
Creating 6 MTD partitions on "spi0.0":
0x000000000000-0x000000040000 : "u-boot"
0x000000040000-0x000000050000 : "u-boot-env"
0x000000050000-0x000000150000 : "kernel"
0x000000150000-0x0000007b0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=2B0000, len=500000
0x0000002b0000-0x0000007b0000 : "rootfs_data"
0x0000007b0000-0x0000007f0000 : "cfg"
0x0000007f0000-0x000000800000 : "EEPROM"
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xba000000, irq 5
eth1: Atheros AG71xx at 0xb9000000, irq 4
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
Distributed Switch Architecture driver version 0.1
eth0[0]: detected a Atheros AR7240 built-in switch
ar8216: Unknown Atheros device [ver=16777215, rev=255, phy_id=004dd041]
ar8216: Unknown Atheros device [ver=16777215, rev=255, phy_id=004dd041]
ar8216: Unknown Atheros device [ver=16777215, rev=255, phy_id=004dd041]
ar8216: Unknown Atheros device [ver=16777215, rev=255, phy_id=004dd041]
dsa slave smi: probed
802.1Q VLAN Support v1.8 Ben Greear
All bugs added by David S. Miller
VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
Freeing unused kernel memory: 152k freed
Please be patient, while OpenWrt loads ...
gpio-buttons driver version 0.1.2
input: gpio-buttons as /devices/platform/gpio-buttons/input/input0
Button Hotplug driver version 0.3.1
eth0: link up (1000Mbps/Full duplex)
- preinit -
Registered led device: dir-600-a1:green:power
Registered led device: dir-600-a1:amber:power
Registered led device: dir-600-a1:blue:wps
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
switching to jffs2
mini_fo: using base directory: /
mini_fo: using storage directory: /overlay
- init -
eth0: link down

Please press Enter to activate this console. eth0: link up (1000Mbps/Full duplex)
eth1: link up (100Mbps/Full duplex)
device lan1 entered promiscuous mode
device eth0 entered promiscuous mode
device lan2 entered promiscuous mode
device lan3 entered promiscuous mode
device lan4 entered promiscuous mode
Generic kernel compatibility enabled based on linux-next next-20100113
cfg80211: Calling CRDA to update world regulatory domain
cfg80211: World regulatory domain updated:
    (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
    (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
    (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
    (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
    (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
    (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
Registered led device: ath9k-phy0::radio
Registered led device: ath9k-phy0::assoc
Registered led device: ath9k-phy0::tx
Registered led device: ath9k-phy0::rx
phy0: Atheros AR9280 Rev:2 mem=0xb0000000, irq=48
cfg80211: Calling CRDA for country: US
cfg80211: Regulatory domain changed to country: US
    (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
    (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
    (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
    (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
    (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
    (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
    (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
nf_conntrack version 0.5.0 (462 buckets, 1848 max)



BusyBox v1.15.3 (2011-09-24 22:03:07 CST) built-in shell (ash)
Enter 'help' for a list of built-in commands.

  _______                     ________        __
|       |.-----.-----.-----.|  |  |  |.----.|  |_
|   -   ||  _  |  -__|     ||  |  |  ||   _||   _|
|_______||   __|_____|__|__||________||__|  |____|
          |__| W I R E L E S S   F R E E D O M
Backfire (10.03, unknown) --------------------------
  * 1/3 shot Kahlua    In a shot glass, layer Kahlua
  * 1/3 shot Bailey's  on the bottom, then Bailey's,
  * 1/3 shot Vodka     then Vodka.
---------------------------------------------------
root@OpenWrt:/# ping 168.95.1.1
PING 168.95.1.1 (168.95.1.1): 56 data bytes
ping: sendto: Network is unreachable
root@OpenWrt:/#                 
root@OpenWrt:/#
root@OpenWrt:/#




＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊




Ａｔｈｅｒｏｓ　７２４０　＋　ＡＲ９２ｘ０
Ｆｌａｓｈ　８ＭＢ
Ｒａｍ　３２ＭＢ

問題是要用ｏｐｋｇ來安裝套件
可是我連ｐｉｎｇ都會失效
請問我哪邊有錯誤了　？　

！